User Guide

AEM00330

Quick Start Guide EVK

FEATURES

Connectors

• 1 screw connector for the source 2 screw connector for AC input signal

• 1 screw connector 1 JST connector for the Storage Element

• 1 screw connector for the application supply

Configuration

• 6 jumpers SRC_LVL_CFG[x] to define the source voltage regulation

• 4 jumpers STO_CFG[x] to define the storage element protection levels

• 4 resistors footprint related to the custom mode (STO_CFG[3:0]=LHHH)

• 3 jumpers LOAD_CFG[x] to define the LOAD voltage

• 1 jumper to set the dual-cell supercapacitor BAL feature

• 4 jumpers to enable the different modes

• 1 jumper to select the rectifier

Size

• 79mm x 49mm

• 4 x M2.5 Mounting holes

SUPPORT PCB

BOM around the AEM00330

Footprint & Symbol: Information available in the datasheet

……………………………………………………………….…………………………………………………………..

PAGE 1
……………………………………………………………….…………………………………………………………..
PAGE 2
STEP 1: AEM00330 Configuration • Source voltage regulation: SRC_LVL_CFG[5] – SRC_LVL_CFG[4] – SRC_LVL_CFG[3] – SRC_LVL_CFG[2] – SRC_LVL_CFG[1] – SRC_LVL_CFG[0] (see datasheet for the table) • Storage Element voltages protection: STO_CFG[3] – STO_CFG[2] – STO_CFG[1] – STO_CFG[0] • LOAD voltage: LOAD_CFG[2] – LOAD_CFG[1] – LOAD_CFG[0] • BAL option: Select “ToCn” for dual-cells supercapacitor and “GND” for any other storage element • Configuration mode: EN_HP – EN_STO_CH – STO_PRIO – EN_SLEEP Connect to H fo
PAGE 3
STEP 2: Connect the storage element STEP 3: Connect the load to LOAD STEP 4: Connect the harvester • Internal Boost efficiency Vs. input voltage in Low Power mode: • Internal Boost efficiency Vs. input voltage in High Power mode: STEP 5: Check the status www.e-peas.com © 2021 e-peas S.A. V1.