Operation Manual

56
›
Settings
Setting the zero point
Beforeautomaticlevellingcanbeactivated,youmustsetthezeropoint.Thisisthepointtowhich
thesystemreturnsinanautomaticcycle.Forsettingthezeropoint,youmustfirstperformamanual
levelling,sothatthevehiclecanbeplacedontherequiredlevel.Onlythen,youwillbeabletosetthe
zero point. Do this by placing a spirit level in the car
Step1 Foractivatingthismode,youmustfollowthenextsequence:
Step 2 Switch off the control panel. Switch on the control panel.
Step3 PressthebuttonFRONT(no.12)fivetimes.
Step 4 Press the button REAR (no. 11) five times.
Step 5 All LEDs will be flashing. You are now in the zero mode.
Step6 PressbuttonRETRACTALL(no.8)threetimeswhileinzeromode,inordertosetthezero
point. Wait 20 seconds, until the system has saved the zero point.
Programming air suspension mode (when installed)
Firstbringthevehicleinlevelposition.
Switch off the control panel. Switch on the control panel.
• PressthebuttonFRONT(no.12)fivetimes.
• PressthebuttonREAR(no.11)fivetimes.
• AllLEDswillbeflashing.
• Youarenowinthezeromode.
• PressbuttonRETRACTALL(no.8)threetimes
• Wait2seconds
• PressagainbuttonRETRACTALL(no.8)threetimes
Now the airsuspension mode is activated.
Switch of control panel.