Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301 71Platform Tuning
The push buttons, on the MDPanel, are used to navigate around a menu to give
access to the various tuning parameters. These parameters are organized into five
groups, 01 through 05. See Table 5-1 on page 72. Each group has three or more
subgroups. With the exception of the Smart U-Frame, all scanners should be able
to operate with ABB SP Default parameter values. These defaults have been stored
in the MDPanel to facilitate ease of setup.
The push buttons used in this application are:
•MENU
• ENTER
• UP/DN arrows
The two buttons to the left are not used. The LCD displays menu selections,
parameter values, and fault conditions. Appropriate parameter units are displayed
along with the values.
Coded alarms which appear on the display can be decoded using Table 5-2 on
page 76.
Motor Drive Parameters
The motor drive that is shipped with the frame will be programmed with the correct
tuning parameters. If the drive is replaced, the values should be checked against
the appropriate default values.
Failure to use the correct values will result in improper
frame operation, burn the windings of the motor, or
produce excessive torque.