Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R130168 Platform Tuning
Platform Software Setup Checklist
Scanning Platform software setup ensures efficient movement of the Scanning
Platform head package and the correct positioning of the head package on the
process sheet.
This checklist is a recommended sequence of steps to correctly set up the Scanning
Platform.
❒ Use the Electronics sections of the Health Reports to make certain there are no
safety interrupts which might impede the setup process.
❒ Check for alarms while tuning the frame. Electronics and Frame alarms are
explained in “Troubleshooting”.
❒ Set up the motor controller (page 77).
❒ Perform basic Scanning Platform tuning–head position calibration and
automatic motor control tuning (page 81).
❒ Set up the Scanning Platform position values (page 88). If required, set up
select positions in the host computer.
❒ Restart the communications between the Host computer and the Scanning
Platform (required to download Host head positions to the Scanning Platform).
❒ Head Package Dimension Setup (page 92).
❒ Set up the Auto Edge-of-Sheet (AEOS) detectors, if configured on the Scanning
Platform (page 97).
❒ Set up the head motion restriction sensitivity if required by the installation site
(page 102).