Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301 65Utility Service Installation
Starting Up the Software
The Service Workstation allows for direct interaction with the Scanning Platform
to allow for initial software loading, tuning of the scanner and sensors, diagnostics,
and monitoring. In order to proceed with platform or sensor setup, the Service
Workstation and the Scanning Platform software must be activated. Once the
Scanning Platform software is loaded in the BRAM of the end column boards, the
content has battery backup for several days, and the platform software can be
repeatedly restarted by means of the RESET button on MPRC, by the power down
and power up cycle, or by Service Workstation commands.
For the initial configuration and software loading of the Service Workstation and
the Scanning Platform, please refer to the appropriate Scanning Platform System
Software Manual, 3BUS 208 [049-054] RXX01.
For subsequent start up, please refer to “Startup Options” on page 169.
Note: It is possible to run the Scanning Platform software independent of
the Host. All procedures, except where specifically noted, can be
executed by local commands using the control panel and Service
Workstation.