Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301 47Hardware Installation
Note: When aligning the head packages, all reference points will be located
on the Basis Weight sensor plate. If a Basis Weight sensor is not
present, use the Ash sensor for the alignment reference. If neither
Basis Weight or Ash sensors are present, use the Basis Weight/Ash
sensor blank base plate.
18. Align the upper and lower base plates of the Basis Weight sensor using the
procedure for Process Direction Alignment beginning on page 48.
19. Continue with the “Air Gap Alignment” on page 50.
20. Perform the “Scan Direction Alignment” on page 52.
Figure 3-13 Pass Angle Adjustment Tool
Carriage Extension Plate
Horizontal
Alignment Rod
Vertical Adjustment Bolt
Vertical Adjustment Bolt
Upper Adapter Plate
Extension
Mounting Bolts
Horizontal
Adjustment Bolt
Upper Adapter Plate
Mounting Bolts
Eccentric
Upper Adapter Plate
Extension Mounting Bolts
Adapter Plate