Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R130140 Hardware Installation
11. Install eight jackscrews in the platform mounting bases.
See Figure 3-8. The four front (inner most) jackscrews should protrude
0.125 - 0.250 in. (3 - 6 mm) below the mounting surface, and the remaining
jackscrews should be flush with the mounting surface.
Figure 3-8 Jackscrew Orientation
12. Connect a heavy duty cable or chain through the two large lifting lugs located
on the top beam of the Scanning Platform.
13. Using the lifting device, secure it to the cable or chains connected to the lifting
lugs.
Drive End Idler End
Inner
Jackscrews
Hold
Down Bolt
Outer
Jackscrews