Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301 39Hardware Installation
Figure 3-7 Preliminary Alignment Setup
9. Check the dimension from the customer pedestals to the process being
simulated by the wires. Make sure that this dimension corresponds to the
dimension on the Scanning Platform specification drawings. These drawings
are customized for each installation site.
10. Temporarily remove the two parallel lengths of wire to allow placement of the
Scanning Platform.
Stretched wire
representing sheet
edge
Weight
(Typical)
Customers
Roll