Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R130134 Hardware Installation
Pedestal Installation and Alignment
The ultimate objective of the pedestal installation and alignment procedure is to
ensure a precise dimensional relationship between the source heads, the detector
heads, and the process. This objective can be achieved by following the guidelines
and procedures in this section.
Installation Guidelines
Observe the following guidelines when installing the Scanning Platform.
• The pedestals must be stable in the machine direction and cross-machine
direction.
• The pedestals must be level in the machine and cross-machine direction.
• The pedestal center lines must be perpendicular to the machine direction and
to the sole plate.
• The top surfaces of the pedestals must be in the same horizontal plane.
• The top surfaces of the pedestals must be at the prescribed distance from the
sheet pass line through the center of the Scanning Platform.
• The height of the Scanning Platform and the angle of the sensor heads may have
to be adjusted to compensate for the process angle.