Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R130128 Hardware Installation
Safety
The Scanning Platform has been designed to comply with ABB and worldwide
standards including the following:
• ABB PA Electrical Safety Directive, 3BDU000002
• ABB PA Machinery Requirements and Policy, 3BUS000159
• ABB PA Field Installation Considerations for Design of Electronics,
3BSE000161
• ABB PA EMC Requirements and Policy, 3BSE000200
The following personnel and machine safety rules should be followed when
installing and operating the Scanning Platform.
Personnel
Symbols appearing on the equipment warn personnel
of potential hazards. Symbols for dangerous voltage
warning, radiation warning, crushing hazard warning,
hand entrapment hazard warning, moving machinery
warning, and a warning that equipment may
automatically start up are shown on the left. Refer to
the explanations in the Caution and Warning Symbols
section at the beginning of this manual.
All people working on the Scanning Platform system
must
know the location of the main power supply
switch to the system and how to operate it.
Service on the SP system is to be performed
only by qualified, trained personnel. Hazardous
voltages exist inside the ABB Smart
Processing Center (ASPC) and in the SP beam.
Work with care when supply voltage is applied in
the SP system. The voltage in the ASPC and the
SP beam can cause injury and can even be fatal.