Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301246 Service Workstation Activities
Service Workstation Setup
To use the Service Workstation for exercising the Scanning Platform you have to
have the following software loaded into the workstation and install a cable between
the workstation and the platform.
Note: For systems manufactured before October 1995
, the ASPC
backplane part number is 086345-003
. For systems manufactured
after October 1995, the ASPC backplane part number is 086345-
004. For a diagram of the -003 and -004 ASPC backplanes, see
Chapter 1, Product Overview.
Software
Refer to the appropriate Scanning Platform System Software Manual,
3BUS 208 [049-054] RXX01.
Hardware
Connect the custom nine–pin connector from the serial port on the Service
Workstation to the debug port (see Figure A-1) on the Scanning Platform.
Figure A-1 Debug Port on the Scanning Platform (-003 Backplane shown)
SYSTEM SERIALJ7
J1 TOP SIGNAL
J2 DRIVE END
P3
P4
P5
TOP POWER
TOP POWER PROGRAM
J3
J4
P1
J6 SERVICE PORT
P2
BOTTOM POWER PROGRAM
TOP SIG
DIAG
J5 DRIVE END
Service Port for the
Scanning Platform