Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301 199Replacement Procedures
2. Loosen the seal belt clamp at the Scanning Platform idler end.
3. Pull the seal belt through the Scanning Platform idler end.
4. Jog sensor heads to the Scanning Platform idler end.
5. Turn off power to the drive motor.
6. Thread the seal belt into position at the idler end under the seal belt roller and
guide through the carriage assembly.
Note: It is extremely important to note that the seal belt should be centered
between the extrusions otherwise the belt may rub the side of the
extrusions while the sensor heads are scanning. This condition
could result in unsteady scanning and premature wear of the seal
belt.
Figure 10-7 Seal Belt
7. Secure the belt at the drive end of the carriage with tape.
8. Turn on the power to the Scanning Platform long enough to jog the sensor heads
to the drive end platform while maintaining enough tension to ensure that the
seal belt does not contact the customer process.
9. Secure the belt at the drive end by threading through the seal belt clamp and
tightening the clamp.
10. Pull the seal belt from the idler end of the platform to remove any slack in the
seal belt.
11. Turn on power to the Scanning Platform long enough to jog the sensor heads
to the idler end, carefully taking up slack in the seal belt.
12. Adjust tension such that the seal belt lays flat in the tray without any deflections
in the seal belt roller assembly.
Carriage Seal Belt Rollers
Seal Belt
Carriage