Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301 185Maintenance Procedures
Platform Alignment Inspection
The alignment inspection recommended for the Scanning Platform consists of
running an air profile at four-week intervals during a time when the process is not
running. Complete the following to perform an air profile:
1. Scan the sensor package with at least ten scans without the process in the gap.
The composite profile weighting factor should be set up for 10 scans.
2. Select and observe the Basis Weight profile on the video monitor.
3. Compare the profile to the profile taken at installation. They should not differ
more than 0.1 grams per square meter (g/m
2
). Consult your measurement
specialist if the profiles differ more than this amount.