Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
xvList of Figures3BUS 208 000 R1301
List of Figures
Figure..................................................................................................Page
Figure 1-1 System Overview ...................................................................... 2
Figure 1-2 Platform Cross Section ............................................................. 7
Figure 1-3 Carriage System ........................................................................ 8
Figure 1-4 Drive System ............................................................................ 9
Figure 1-5 Electrical Component Locations ............................................... 10
Figure 2-1 Shutter Status Lights on Lower Carriage and End Column ..... 17
Figure 2-2 Types of Safety Labels Used on Shipping Containers ............. 18
Figure 2-3 Safety Labels ............................................................................ 20
Figure 2-4 Safety Label for the X–ray Sensor ............................................ 21
Figure 2-5 Measurement Beam .................................................................. 22
Figure 3-1 Scanning Platform on Shipping Dollies ................................... 24
Figure 3-2 Rigging Recommendations ....................................................... 26
Figure 3-3 Liquid Cooling Unit Setup ........................................................ 33
Figure 3-4 Alignment of the Mounting Pedestals ...................................... 35
Figure 3-5 Attaching Drive Side of Scanning Platform to Pedestals ......... 37
Figure 3-6 Platform to Pedestal Installation – Idler Side .......................... 38
Figure 3-7 Preliminary Alignment Setup ................................................... 39
Figure 3-8 Jackscrew Orientation ............................................................... 40
Figure 3-9 Verifying Platform Alignment .................................................. 42
Figure 3-10 Head Alignment Conditions ..................................................... 44
Figure 3-11 Pass Angle Adjustment ............................................................. 45
Figure 3-12 Simulating the Process Pass Line ............................................. 46
Figure 3-13 Pass Angle Adjustment Tool .................................................... 47
Figure 3-14 Process Direction Alignment Points ......................................... 48
Figure 3-15 Air Gap Alignment Points ........................................................ 51
Figure 3-16 Scan Direction Optimum Alignment Point .............................. 52
Figure 3-17 Scan Direction Adjustment ....................................................... 53
Figure 3-18 Manual Alignment Setup .......................................................... 54
Figure 4-1 Purge Air Duct Attachment ...................................................... 56
Figure 4-2 Air and Water Hookup .............................................................. 58
Figure 4-3 Standard Cable Configuration .................................................. 60
Figure 4-4 Circuit Breakers ........................................................................ 61
Figure 5-1 Menu Tree ................................................................................. 69