Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301154 Measurement Setup
Enabling APC for Normal Measurement
1. Using the inspect utility, turn on the flag to enable air profile compensation. At
the inspect prompt type:
betaSensor01->airProfileCompOn = 1 (for Basis Weight)
ashSensor01->airProfileCompOn = 1 (for Ash)
caliperSensor01->airProflieCompOn = 1 (for caliper)
topGlossSensor01->airProfileCompOn = 1 ( for Top Gloss)
bottomGlossSensor01->airProfileCompOn = 1 (for bottom Gloss)
optipakSensor01->opacityAirProfileCompOn = 1 AND
optipakSensor01->brightnessAirProfileCompOn = 1 (for OptiPak)
2. If this is to be the normal mode of operation, save the flag settings using the
gstore utility. The frame graph should be saved.