Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301 153Measurement Setup
3. One can set the box width resolution of the air profile independent of the normal
profile resolution. One should NOT set this resolution to be finer than the normal
profile. Using a larger value sets the box width larger and averages more data
per data box. The inspect utility should be used as follows:
betaSensor01->airProfileResolution = x.x (for Basis Weight)
ashSensor01->airProfileResolution = x.x (for Ash)
caliperSensor01->airProflieResolution = x.x (for caliper)
topGlossSensor01->airProfileResolution = x.x ( for Top Gloss)
bottomGlossSensor01->airProfileResolution = x.x (for bottom Gloss
optipakSensor01->opacityAirProfileResolution = x.x AND
optipakSensor01->brightnessAirProfileResolution = x.x (for OptiPak)
4. From the Host, disable auto-edge-of-sheet.
5. If a Gloss sensor is present, insert a sample of the most common grade into
the sensor gap. The air to the air bearing sheet guides must be turned off and
the sample must be stretched very tightly without any ripples.
If an Optipak sensor is present, place a sample of the process that simulates
the typical process in the gap of the OptiPak before requesting a standardize.
6. Put the system in Health Page control.
7. Set the sheet-break override.
8. On the Health Overview Page for DESQView system or Frame Report for the
NT-based system, specify that air profile collection is desired.
For the DESQView system, select “AIR COMP” for the Head Command.
For the NT system, select the check box labeled “APC Collection On”.
9. Request the system to scan.
10. From the same Health Report, as in step 7 there will be a message indicating
the system is in air profile collection mode and it will indicate the number of
scans that have been completed.
11. Let the system scan 10 times and it will automatically terminate.
12. From the Host, turn auto-edge-of-sheet on
13. If the bit was inverted to cause a sheet-break to be present, use the dim utility
to restore the sheet-break input processing.
14. If Gloss or OptiPak is present, remove the sample from the applicable sensor.
15. Save the changes using the gstore utility.