Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301140 Measurement Setup
Caliper Sensor
The Caliper sensor is unique in that only the nominal values may be set by the user.
Ranges, both for failure and maintenance, are calculated internally. The failure
range is calculated every time the nominals are changed. The maintenance range
is calculated only when a clean standardize has been selected.
See Table 6-23 for the acceptable range of standardize limits for the Basis Weight
sensors.
Figure 6-14 NT Workstation Caliper Health Report - Standardize Limits