Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301 129Measurement Setup
Figure 6-10 Gloss Sensor Calibration Report
2. If a current value is to be changed, enter a 1 and continue to the next step. If
you wish to redisplay the constants, enter a 2 and observe the screen refresh.
If you wish to calculate new constants, enter a 3 and follow the interactive
instructions. If no changes are to be made, answer q and skip to Step 6.
3. If 1 is selected, the console will then ask which variable is to be changed. Enter
the variable number. If 3 is selected, go to the “Gloss Sensor Head Constant
Tuning” on page 130.
4. The console will then confirm the variable name and wait for the new value to
be entered.
5. The console will ask again if a variable is to be changed. If yes, answer y and
go back to Step 3. If no, answer n and continue.
6. The console will give instructions regarding the selection of another report if
desired. If no, answer n and the utility will exit to the AVOS shell ($$). If yes,
answer y and the utility will restart as if genrpt had just been entered.
GENERAL SENSOR REPORT TUNING UTILITY; rev date 8 Sep. 1989.
Enter the name of the sensor you wish to view.
TopGlossSensor01
Do you wish to view Standardize variables or Calibration constants? (s or c)
c
GLOSS SENSOR CALIBRATION CONSTANTS TUNING UTILITY; rev. date 27 Mar., 1990.
Current Calibration Constants
Variable Name
1: headConstant1
2: headConstant2
Current Value
26.00000
0.000000
Enter 1 to change head constants
2 to re–display head constants
3 to calculate new head constants
q to exit
Do you wish to view another sensors report? (y or n) n