Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301128 Measurement Setup
Sheet Temperature Sensor
Use the Sheet Temperature Health Reports to change the calibration constants.
Figure 6-9 shows an example of the Temperature Health Report.
For instructions on calibrating the Sheet Temperature sensor, see the Sheet
Temperature Sensor Reference Manual, 3BUS 208 123 RXX01.
Figure 6-9 NT Workstation Temperature Health Report - Calibration
Gloss Sensor
Table 6-20 identifies the variable names of the two head constants. Enter the values
you read from the sensor head nameplate into the specified instance variable column
and store them in the frame community using the gstore utility.
Table 6-20 Head Constants for the Gloss Sensor
1. At the $$ prompt, type genrpt.
The current calibration head constants, giving variable name and current value,
will be displayed on the console. The bottom portion will be an interactive
question about changing, redisplaying, or recalculating the current values. See
Figure 6-10.
NamePlate
Name
Instance Variable
Name
Value
GL1HC1 headConstant1
GL2HC2 headConstant2