Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301 121Measurement Setup
Changing Caliper Output Units
To change the output units for the Caliper sensor, access the Caliper Health Report.
See Figure 6-4.
1. Select the Measurement tab.
2. Select the Current tab.
3. In the Measurement Units area, click the desired units.
Figure 6-4 NT Workstation Caliper Health Report
Ash Units Setup
Ash units are determined by the Host computer. Refer to the Host computer
documentation for setup of percent basis weight, percent bone dry weight, and ash
weight.