Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301 107Measurement Setup
6
Measurement Setup
Measurement setup consists of a set of procedures that involve both the sensor and
the Scanning Platform. Specific sensors have additional hardware setup procedures
that are located in the specific sensor manuals. Refer to the Setup Checklists for
the setup procedures sequence for each sensor.
This chapter contains the following major sections:
Section ...............................................................................................Page
Setup Checklists ............................................................................................. 108
Operation of NT Workstation Health Reports ............................................... 112
Temperature Controller Setup for Basis Weight, Ash, and Caliper Sensors .. 115
Setup of Customer Units ................................................................................ 120
Enter Calibration Head Constants .................................................................. 122
Standardize Limits ......................................................................................... 132
Verification ..................................................................................................... 146
Air Temperature Compensation for Basis Weight (TLK-5/-8/-9 ONLY) ...... 148
Air Profile Compensation for Ash, Basis Weight (TLK-5/-8/-9), Caliper, Bottom
& Top Gloss, and OptiPak ....................................................................... 152
Digital Input Invert Adjustment for the Smoothness Sensor ......................... 155
Default Compensations for IR Moisture, Microwave, & Ash Sensors .......... 156
Calibrate Sample - Minimum Time Data Accumulation ............................... 157