Specifications

PROPRIETARY DATA: This document contains proprietary data of ABB Inc. No disclosure, distribution (electronic or otherwise),
or other means of dissemination may be made without written permission.
3BUS 208 000 R1301 91Platform Tuning
Procedure for Determining Position Values
Mark the locations of the machine center line, the Minimum Home Measure
Position, and the Maximum Far Measure Position on the Scanning Platform for
future reference.
Note: If you have trouble using the Jog push buttons on the Scanning
Platform control panel because the system is too responsive, slow
down the jog speed using the Frame Health Report.
1. Select the Frame Health Report. If necessary, refer to ”Operation of NT
Workstation Health Reports” on page 112.
2. Use the JOG push buttons on the Scanning Platform end column to move the
head package to the desired position.
3. Record the current head position as displayed on the Health Report.
4. Repeat Steps 2. and 3. for each of the fixed frame positions.
5. Enter values in customer units in the appropriate data fields of the Health Report.
See Figure 5-14.
6. Remember to do a gstore to make changes permanent.
Figure 5-14 NT Workstation Frame Health Report - Scanner Setup