Specifications

Proteus 2000 Operation Manual 123
Edit Menu
FXB Parameters
FXB Parameters The FXB parameters are Feedback, LFO Rate and Delay. Feedback sends the
output of the effect back into the input. This creates multiple echoes on a
delay effect and intensifies a chorus or flange effect. LFO Rate allows you to
change the speed of the modulation oscillator for flange and chorus effects.
Delay sets the length of the delay line. This affects the time between
echoes, or the tone of flange effects.
FXB Send Amounts These parameters set the effects amounts for the four stereo effects busses.
Preset Patchcords Preset PatchCords give you real-time control of global parameters. The
effect processors are a powerful synthesis tool and this feature lets you
control and use them in exciting new ways. There are 12 effects PatchCords
per preset with a source, a destination and an amount control. The amount
can be set from -100 to +100. The effects PatchCord controls are added to
the FX Send Amounts set in the Master or Edit menus.
OO
OO
The FX Cords allow you
to crossfade between effects.
1) Set FXA Send 1 to 100%.
2) Set FXB Send 1 to 0%.
3) Set FX Cord #1 to FXA Send 1
at -100.
4) Set FX Cord #2 to FXB Send 1
at +100.
Increasing the controller amount
will crossfade from FXA to FXB.
FXB FEEDBK LFORATE DELAY
032 003 200ms
FXB SEND AMOUNTS 1:100%
2: 50% 3: 10% 4: 0%
Modulation Sources: Modulation Destinations
Off Off
PitchWhl (Pitch Wheel) Effect A Send 1
Channel Pressure Effect A Send 2
ModWhl (Mod Wheel - Controller 1) Effect A Send 3
Pedal (Controller 4) Effect A Send 4
MIDI Volume (Controller 7) Effect B Send 1
MIDI Pan (Controller 10) Effect B Send 2
MIDI A-L Effect B Send 3
Footswitch 1 Effect B Send 4
PRESET CORDS
#
Pedal -> FXBSend2 +100