User Guide

Orbit V2 Operation Manual8
If a stereo plug is inserted, the Ring of the stereo plug serves as a signal
Return which sums into the Main outputs.
Therefore, the Sub 1 and Sub 2 jacks can serve as effect sends and
returns in order to further process selected instruments and then
return them to the main mix.
The diagram shows the Sub 1 and Sub 2 jacks being used as send/
returns in order to further process selected Orbit presets without using
the effects bus on the mixing board. In a pinch, the effect returns
could also be used to sum additional instruments into the main
outputs.
The Sub 1 and Sub 2 jacks can be used as effect returns to the Main Outputs.
POWER UP!
The power switch is located on the right side of the front panel. Orbit
and its MIDI controller may be turned on in any order. When power is
applied, the liquid crystal display will light, indicating that Orbit is
operating. You may have noticed that there is no 110/220 Volt power
selector switch on Orbit.
ORBIT AUTOMATICALLY SWITCHES ITSELF TO THE
PROPER LINE VOLTAGE.
CONNECTIONS
••• Inserting a standard
mono phone plug halfway
into the jack allows you to
sum into the main outputs
without a special cable.
MAINS
RL
R Bus
L Bus
Output Section
Tip
Ring
Tip
Ring
SUB 1
RL
Tip
Ring
Tip
Ring
SUB 2
RL