Instruction Manual

Chapter 5 Configuring the PowerSmart+ PQM Configuring Communication Protocols
PowerSmart+ Power Quality Meter 107
3. Specify the start point index and the number of points in the
range. Refer to the PowerSmart+ PQM DNP3 Reference Guide
for available data points.
4. Repeat these steps for all point ranges you want to be included
into the Class 0 response.
5. Click Send to download your setup to the meter.
The factory-set Class 0 point ranges are shown in the picture below.
Figure 5-23: Protocol Setup Dialog Box – DNP Class 0 Points Tab