User Manual
Chapter 4 Power Software Configuration tool
Changing Port Settings
Multi-Mon Multiple Circuit Energy Monitor
41
NOTE
NOTENOTE
NOTE
When using the ExpertPower
When using the ExpertPowerWhen using the ExpertPower
When using the ExpertPower
client (see
client (see client (see
client (see Configuring eXpertPo
Configuring eXpertPoConfiguring eXpertPo
Configuring eXpertPower Client
wer Clientwer Client
wer Client),
), ),
),
submeter address 99 on the Ethernet port COM2 is reserved for the
submeter address 99 on the Ethernet port COM2 is reserved for the submeter address 99 on the Ethernet port COM2 is reserved for the
submeter address 99 on the Ethernet port COM2 is reserved for the Multi
MultiMulti
Multi-
--
-
Mon
MonMon
Mon router and must not fall inside the range of the submeter addresses for
router and must not fall inside the range of the submeter addresses for router and must not fall inside the range of the submeter addresses for
router and must not fall inside the range of the submeter addresses for
this port.
this port.this port.
this port.
Setting Up the Local Network
Setting Up the Local NetworkSetting Up the Local Network
Setting Up the Local Network
To enter the setup dialog, select the device site from the list box on the
Power Software toolbar, select Communications Setup from the Meter Setup
menu, and then click the Network Setup tab.
To change the Ethernet settings in your device, select desired parameters,
and then click Send. For the available options, see Local Network Settings in
Chapter 3.
Configuring eXpertPower Client
Configuring eXpertPower ClientConfiguring eXpertPower Client
Configuring eXpertPower Client
The Multi-Mon has an embedded eXpertPower
TM
client that provides
communications with the eXpertPower
TM
server – Cloud AMR services.
Connections to the eXpertPower
TM
server are handled on a periodic basis.
To enter the Setup dialog, select the site from the list box on the Power
Software toolbar, select Communication Setup from the Meter Setup menu,
and then click the ExpertPower Client Setup tab.
The following table lists available options. Refer to your eXpertPower service
provider for the correct eXpertPower settings.
Parameter
ParameterParameter
Parameter
Options
OptionsOptions
Options
Default
DefaultDefault
Default
Description
DescriptionDescription
Description
XPW Server IP Address
207.232.60.
18
The IP address of the
eXpertPower server
XPW Server Port 0-65535
5001
The TCP service port of the
eXpertPower server