User Manual

Chapter 3 Multi-Mon Display Operations
Menu Operations
32
Multi-Mon Multiple Circuit Energy Monitor
Label
LabelLabel
Label Parameter
ParameterParameter
Parameter Options
OptionsOptions
Options Default
DefaultDefault
Default Description
DescriptionDescription
Description
Ratio V1
Ratio V1Ratio V1
Ratio V1-
--
-V3
V3V3
V3
V1-V3 voltage
transformer
ratio correction
factor
0.700 to 1.300 1.000
The ratio of the true
transformer ratio to the
marked ratio.
Angle V1
Angle V1Angle V1
Angle V1-
--
-V3
V3V3
V3
V1-V3
transformer
phase angle
error, minutes
-600 to 600
0
The phase
displacement, in
minutes, between the
primary and secondary
values. The phase
angle of a voltage
transformer is positive
when the secondary
value leads the primary
value.
Ratio I1
Ratio I1Ratio I1
Ratio I1-
--
-I
II
I36
3636
36
I1-I36 current
transformer
ratio correction
factor
0.700 to 1.300 1.000
The ratio of the true
transformer ratio to the
marked ratio.
Angle I1
Angle I1Angle I1
Angle I1-
--
-I36
I36I36
I36
I1-I36
transformer
phase angle
error, minutes
-600 to 600
0
The phase
displacement, in
minutes, between the
primary and secondary
values. The phase
angle of a current
transformer is positive
when the secondary
value leads the primary
value.
Device Options
Device OptionsDevice Options
Device Options
This menu allows you to select some user-configurable device options or put
the Multi-Mon into energy test mode.
To enter the menu, select the Options entry from the main menu, then press
ENTER. For instructions on navigating in the menu, see Viewing and
Changing Setup Items.
The following table lists available options.
Label
LabelLabel
Label Parameter
ParameterParameter
Parameter Options
OptionsOptions
Options Default
DefaultDefault
Default Description
DescriptionDescription
Description
PowMode
PowModePowMode
PowMode
Power
calculation
mode
Reactive,
NonActive (non-
active power)
Reactive
The method used for
calculating reactive
and apparent powers
ErgyRoll
ErgyRollErgyRoll
ErgyRoll
Energy roll
value
100000.0-
100000000.0
kWh
100000000.0
The value at which
energy counters roll
over to zero
TestMode
TestModeTestMode
TestMode
Energy test
mode
OFF, Wh, varh OFF
Setting this option
puts the device into
the energy test mode
PlsConst
PlsConstPlsConst
PlsConst
Wh LED pulse
rate,
Wh/pulse
0.01-100.00
5.40Wh/pulse
(one
equivalent
disk
revolution)
LED pulse constant -
the amount of
accumulated energy
giving one pulse via
“Wh” LED
WhLEDSrc
WhLEDSrcWhLEDSrc
WhLEDSrc
Energy LED
source
1-40, None 1
Selects a submeter as
a LED pulsing source
Communication Ports
Communication PortsCommunication Ports
Communication Ports
These two menus allow you to configure parameters for communication
ports COM1 and COM2. The Multi-Mon automatically detects a replaceable
communication module and will not allow you to change the baud rate and
data format for the Dial-up modem, and for the Ethernet and RF modules.
Options
Exit
Options
PowMode
Reactive
ENTER