Owner's manual
DIN-MON™ SMART METER
3 62-0442—04
Section 4.5.3 Current Sensor Wiring...................................................... 23
Section 4.5.4 Multiple-Load Monitoring .................................................. 24
Section 4.6 Main Power and Current Sensor Wiring Diagram.................. 25
Section 4.6.1 4-Wire Wye, 3-Element Connection Diagram................... 25
Section 4.6.2 3-Wire Delta, 3-Element Connection Diagram ................. 25
Section 4.6.3 3-Wire, 2-Element Connection Diagram........................... 25
Section 4.6.4 2-Wire, 1-Element Connection Diagram........................... 26
Section 4.7 Installation Diagnostics.......................................................... 27
Section 4.7.1 Line Voltage Diagnostics .................................................. 27
Section 4.7.2 Current Sensor Diagnostics ............................................. 27
Section 4.8 Wiring the Communications................................................... 29
Section 4.8.1 RS-485 Network and Wiring............................................. 29
Section 4.8.2 Meter RS-485 Wiring........................................................ 30
Section 4.8.3 USB Key Wiring................................................................ 30
Section 4.8.4 Ethernet Wiring (Optional on D5 Models Only) ................ 31
Section 4.8.5 LonWorks Wiring (Optional on D5 Models Only).............. 32
Section 5.0 Communication Protocols........................................................... 34
Section 5.1.1 Modbus RTU .................................................................... 34
Section 5.1.2 BACnet MS/TP ................................................................. 34
Section 5.1.3 Baud Rate and Settings on RS-485 ................................. 34
Section 5.1.4 Modbus TCP/IP ................................................................ 35
Section 5.1.5 BACnet IP......................................................................... 35
Section 5.1.6 LonWorks TP/FT-10.......................................................... 35
Section 5.1.7 EZ7 on RS-485 and Ethernet ........................................... 35
Section 6.0 External Interface ....................................................................... 36
Section 6.1 Pulse Output.......................................................................... 36
Section 6.2 Pulse Type and Value ............................................................ 37
Section 7.0 Setting Up the Meter Using the Push Buttons............................ 38
Section 7.1 Navigating Menus .................................................................. 38
Section 7.1.1 Setup Menu Screens........................................................ 39
Section 7.2 Configurable Settings from the Display Menu........................ 41
Section 7.2.1 Setting Date and Time...................................................... 42
Section 7.2.2 Setting Device ID (Modbus).............................................. 42
Section 7.2.3 Setting Device ID (BACnet) .............................................. 43
Section 7.2.4 Setting Ethernet IP Address ............................................. 43
Section 7.2.5 Setting Pulse Value .......................................................... 44