User manual

Screw securing glue shall

be applied on the threads.

Note:

1. When installing the tripod turnstile against the wall, please reserve at least 100 mm space in order to open the cover for adjustment

and maintenance.

2. The space at the end of the arm shall not be greater than 80 mm (see figure 3-1).

3. Setting a warning line for card swiping (see figure 3-2). A warning line is suggested to prompt users to swipe cards in a distance,

which would greatly reduce the probability of equipment failure caused by improper operations.

Warning line for card swiping

Figure 3-2

3.2 Cabling

There are inlets in the bottom plate for cabling, as shown in figure 3-3. Power supply and communication wire should go through the

inlet. Cable protection covers are suggested to use if it is surface mounted.

Warning: The tripod turnstile must be connected to Ground (earth), there is wiring interface in the power switch.

945.00mm

176.00mm

Figure 3-3

3.3 Installation

1. Drilling holes

Drill holes based on the locations of the holes shown in figure 3-3.

2. Fix the mounting plate to its original position

Placing the mounting plate properly and apply screw securing glue on the surface and the threads of the expansion bolts, install four

expansion bolts to secure the mounting plate, and use a horizontal ruler to test the levelness of the mounting plate. If the mounting

plate is not level, adjust it by the gaskets provided. Note that all the four expansion bolts must be installed properly, and two

expansion bolts on each column, as shown in figure 3-4.

Figure 3-4

3. Put the turnstile on the mounting plate and tighten the screws. Apply screw securing glue before use and put gaskets on the screws

to adjust the direction of the turnstile. If the tripod turnstile is not level, you can place gaskets to adjust, as shown in figure 3-5.

Figure 3-5

Installation levelness