User manual

H900 Series Cellular Router User Manual
To configure the NAT function, you need to go to the following configuration interface:
Fig. 3.3.7.1-5: NAT Setting Interface
NAT configuration parameters include:
【Name】: Set the name mapped by NAT port.
【Protocol】: Set the protocol mapped by NAT port.
【Outside Interface】: Select the interface on which NAT function acts.
【Outside Port】: Set the outside port number mapped by NAT port.
【Inside Address】: Set the IP address of LAN host mapped by NAT port.
【Inside Port】: Set the port number of LAN host mapped by NAT port.
3.3.7.2 Static route configuration
In the “Forward” main tab, click the “Static Route” sub-tab to set the static route
parameters and go to the following configuration interface:
Fig. 3.3.7.2-1: Static Route Configuration Interface