Specifications

Technical Data

9.2 Pin Assignments

9.2.1 Digital In/Out Socket

Connector type: MDR14

Pin Signal Function

1 GND GND

2 nc not connected

3 output DIO_O3 (TTL, this digital output line can be

configured with the CTO, TWS and WGO commands

for triggering tasks, identifier is 3); with E-517.i3 only

4 output DIO_O2 (TTL, this digital output line can be

configured with CTO, TWS and WGO for triggering

tasks, identifier is 2); with E-517.i3 only

5 output DIO_O1 (TTL, this digital output line can be

configured with CTO, TWS and WGO for triggering

tasks, identifier is 1)

6 nc not connected

7 nc not connected

8 reserved reserved 2

9 reserved reserved 1

10 nc not connected

11 input DIO_I3 (TTL, digital input line 3, for start and

synchronization of wave generator 3 , see WGO

command); with E-517.i3 only

12 input DIO_I2 (TTL, digital input line 2, for start and

synchronization of wave generator 2, see WGO);

with E-517.i3 only

13 input DIO_I1 (TTL, digital input line 1, for start and

synchronization of wave generator 1, see WGO)

14 reserved reserved

The signal state of the DIO_I1 to DIO_I3 input lines can be queried with the DIO? command.

9.2.2 RS-232 Socket

Connector type: Sub-D 9 pin (m)

Pin Function

1 nc

2 RXD receive data

3 TXD send data

4 nc

5 DGND ground

6 nc

7 RTS Hardware handshake, output

8 CTS Hardware handshake, input

9 nc