Specifications

Communication

Adapt

IP address and

Subnet mask; do not

change the

Default

gateway

setting

Press OK

Figure 5: Internet Protocol (TCP/IP) Properties

window, the settings shown are only

examples, maybe they does not match

that of your controller

If you want to change the IP address and IP mask settings of

the E-517:

1 Establish a serial connection between PC and E-517 as described

"RS-232 Serial Connection" (p. 53).

2 Use the IFS command in the command entry facility of the program

to adapt the IP address and IP mask settings of the E-517 to those

of the PC (to check the PC settings, you can open the

Internet

Protocol (TCP/IP) Properties

window as described above):

To change the IP mask (subnet mask), send

IFS 100 IPMASK

mask

mask must be identical to the Subnet mask setting of the PC.

To change the IP address, send

IFS 100 IPADR

address

At least the last portion of the IP address

must be different from

that of the PC and any other device in the same network (the

applicable address settings depend on the IP mask setting). If, for

example, the PC has the IP address 172.21.0.1, send

IFS 100 IPADR 172.21.0.2:50000