Specifications

Communication

3 In the Properties window of the LAN connection, click on Internet

Protocol (TCP/IP)

4 In the Internet Protocol (TCP/IP) Properties window, activate Use

the following IP address.

Make a note of the current IP address

and Subnet mask settings, if any, in case they need to be restored

later. Then adapt the

IP address and Subnet mask settings to

make them compatible with the settings of your E-517:

Set the first three portions of

IP address identical to those of the IP

address of the E-517, while the last portion must be different. One

possible

IP address setting would be, for example, 192.168.168.2

(the default IP address of the E-517 is 192.168.168.10). Do not use

"255" for the last portion.

Set

Subnet mask to 255.255.255.0 (if the IP mask of the E-517 is

255.255.255.0).

Confirm with

OK. An example is shown in the figure below.

5 Connect the E-517 to the Ethernet card in the PC using the

included, special, cross-over cable ("point-to-point" connection). If

a hub is used to allow for connection of several devices to the PC,

connect the E-517 to the hub using the straight-through network

cable.

6 Power on the E-517.

7 Use the "Search for controllers" functionality, described in

"Network

with DHCP Server"

(p. 48), to establish the connection between PC

and the E-517.

NOTE

If the connection fails, change the last portion of the IP address setting

on the PC and try again to connect via "Search for controllers".