Specifications

Introduction

1.4 Model Survey

The following E-517 models are available:

E-517.i3 Interface / Display Module, 24 Bit D/A, TCP/IP, USB,

RS-232, 3 Channels

E-517.i1 Interface / Display Module, 24 Bit D/A, TCP/IP, USB,

RS -232, Single Channel

The E-517 comes normally installed in the chassis of the analog piezo

control electronics, in the configuration ordered by the customer. The

system is calibrated at the factory and ready for use.

E-516 COMPATIBILITY NOTE

Users who have written software for the E-516 interface / display

module which is the predecessor of the E-517 can switch to the GCS

syntax used with the E-516, see "Select Command Set Version" (p.

41). PI software and documentation for the E-516 GCS syntax version

is available for download at www.pi.ws or can be obtained from your

Physik Instrumente Sales Engineer.

1.5 Unpacking

The E-517 Digital Piezo Controller Operation Module usually comes

installed in an analog piezo control system. Unpack the system with care.

Compare the contents against the items covered by the contract and

against the packing list.

The E-517 includes the following components:

■ E-517 Digital Piezo Controller Operation Module as covered by the

contract

■ C-815.34 RS-232 cable for connecting E-517 and host PC

(null-modem cable)

■ C-815.563 special cross-over network cable, can be used to connect

the E-517 to a network access point or to a PC with Ethernet socket

■ 000011448 USB cable (USB-A/USB-B)