User`s manual

Figure 3-2

3.1.3 Remove Lens

Please follow the steps listed below to remove lens. The interface is shown as in Figure 3-3.

z Turn the lens counter clockwise and then remove it from the camera.

z Unplug the auto lens cable socket from the auto lens connector. If you are using the manual

aperture lens, please skip to the following step.

z If there is no lens, please put the CCD protection cap back to protect the CCD.

Figure 3-3

3.2 SD Card

3.2.1 Installation

Please follow the steps listed below to install SD card. The interface is shown as in Figure 3-4

and Figure 3-5.

z Use the screwdriver to loosen the SD card protection screw in the rear panel, and then

remove the SD card protection cap from the camera.

z Install the SD card to the camera according to the proper installation position.

z Put the SD card protection cap back.

z Use the screwdriver to fix the SD card protection cap screw firmly to secure the SD card

protection cap in the camera.