User manual

User Manual of Network Camera

2. Study the code of the remote control or the wireless alarm.

 To study a remote control, select Remote Control from the Study drop-down list,

and click ; and then press any of the buttons on the remote control

against the camera to send the signal.

 To study the wireless alarms, e.g. the access control device, select Wireless

Alarm from the Study drop-down list, and select the device serial number (1-8)

from the drop-down list, and click ; and then send the signal from the

wireless alarm device to the camera.

Figure 5-38 Study the Wireless Alarm

Notes:

 The camera can study up to 4 remote controls.

 To study the access control device, you can open the door/separate the device to

send the signal.

Configure the Wireless Alarm and PIR Alarm

 Configure the Wireless Alarm

Steps:

(1) Enter the Wireless Alarm Settings interface:

Configuration > Advanced Configuration > Events > Other Alarm

(2) Select the wireless alarm number. This camera supports up to 8 channels of

external wireless alarm input.

Figure 5-39 Wireless Alarm Settings

(3) Check the checkbox of Enable Wireless Alarm to activate the alarm and define