Specifications

6 C2983M-A (12/10)
Figure 4. Line-Out Audio Wiring
4. Install the back box:
a. Insert the back box into the hole in the ceiling/wall. Be sure to angle the back box during this
step to ensure that the wiring is inserted into the hole first and is not bent or damaged.
b. Use two 3/16-inch toggle bolts (not supplied) to attach the back box to the mounting surface
(refer to Figure 5).
Figure 5. Fixed Ceiling or Wall Installation
5. Apply power to the camera.
NOTE: If the camera is not connected to a DHCP server and DHCP is enabled, the configuration
sequence might take up to five minutes to complete.
ì
Speaker
î
Amplifier
ï
600-Ohm Impedance Matching Transformer
ñ
Line Out – (Red)
ó
Line Out + (Orange)
ì
Ceiling/Wall
î
Back Box
ï
3/16-inch Toggle Bolts (not supplied)
+
–