Specifications

10 C2983M-A (12/10)
Operation
IP ADDRESS SETTINGS
If the camera is connected to a Dynamic Host Configuration Protocol (DHCP) network and DHCP is set to
the On position, the server will automatically assign an IP address to the device; DHCP On is the default
setting for the camera. Set DHCP to the Off position to manually set the camera’s IP address.
NOTES:
• If the camera is not connected to a DHCP server but DHCP is set to On, the default IP address
192.168.0.20 on subnet mask 255.255.255.0 is automatically assigned to the camera. After the first
camera is connected and assigned the default IP address, the system will automatically look for
other cameras on the auto IP address system and assign IP addresses in sequential order as
required.
For example, if three cameras are connected to a network without a DHCP server, the first camera is
assigned address 192.168.0.20, the second camera is assigned address 192.168.0.21, and the third
camera is assigned address 192.168.0.22.
• Contact your network administrator to avoid network conflicts before setting or changing the
camera’s IP address.
• If you do not know the camera’s IP address, install the Pelco Device Utility software available on the
resource disc supplied with the product. The utility will locate the assigned name, IP address, and
MAC address for devices connected to the same virtual local area network (VLAN) as your computer.
The Device Utility software is also available at www.pelco.com/software/downloads/.
MINIMUM SYSTEM REQUIREMENTS
The following minimum system requirements are needed to use a Web browser with the IP camera:
Processor: Intel
®
Pentium
®
4 microprocessor, 1.6 GHz
Operating system: Microsoft
®
Windows
®
XP, Windows Vista
®
, or Mac
®
OS X 10.4
Memory: 512 MB RAM
Network interface card: 100 megabits (or greater)
Monitor: Minimum of 1024 x 768 resolution, 16- or 32-bit pixel color resolution
Web Browser: Internet Explorer
®
7.0 (or later) or Mozilla
®
Firefox
®
3.0 (or later)
NOTE: Internet Explorer is not supported by Mac OS X 10.4.
Media Player: Pelco’s Media Player or QuickTime
®
7.6.5 for Windows XP, and Windows Vista, or
QuickTime 7.6.4 for Mac OS X 10.4 (or later).
NOTE: This product is not compatible with QuickTime version 7.6.4 for Windows XP, or Windows Vista.
If either operating system is installed on your computer, upgrade to QuickTime version 7.6.5.