Installation Instructions

ManualsBrandsE. L. Mustee ManualsBathMustee Stylemate 60" x 30" White Bathtub Wall Surround

TOOLS REQUIRED MATERIAL REQUIRED

Tape Measure Adhesive – Recommend LIQUID NAILS

for TUB SURROUNDS & SHOWER WALLS (LN-915).

Razor Knife Do not use adhesives containing tar, asphalt, lacquer thinner or toluene.

Straight Edge/Level Caulking/Waterproof

Drill Masking Tape

Drill Bits/Hole Saw Mineral Spirits

Caulking Gun

CARE/CLEANING

The surface of your wall surround may be cleaned with a mild soap solution in warm water using a soft cloth. For stubborn stains use SoftScrub by Clorox

or a powdered detergent such as Spic-n-Span. Never use abrasive scouring powder or steel wool pads as they will dull and scratch the surface. A periodic

coating of a silicone based marine polish will help retain the fine finish.

1. Determine the size of your bathtub – measure along the top of the tub at the

back wall; using a level, draw a centerline approximately 60” inches high. Also

measure each side wall. This wall surround is designed to fit a 30” X 60”

bathtub without any trimming. Turn off both hot and cold water supply to

bathtub. Remove the existing fixture trim, spout, handles and any soap dishes

or towel racks that protrude into the alcove area. Before applying panels, be

sure all surfaces are clean, fairly smooth and dry.

SI-101 (5•02)

NOTICE

We recommend that tub/shower compartments be equipped with support

handrails that comply with the most recent edition of ANSI-117.1 requirements.

INSTALLATION

Read instructions thoroughly before attempting installation.

Place some sort of protective cover (may be cut from carton) over the floor of the

bathtub to protect the finish.

Summary of content (2 pages)

PAGE 1
TOOLS REQUIRED MATERIAL REQUIRED Tape Measure Razor Knife Straight Edge/Level Drill Drill Bits/Hole Saw Caulking Gun Adhesive – Recommend LIQUID NAILS® for TUB SURROUNDS & SHOWER WALLS (LN-915). Do not use adhesives containing tar, asphalt, lacquer thinner or toluene. Caulking/Waterproof Masking Tape Mineral Spirits CARE/CLEANING The surface of your wall surround may be cleaned with a mild soap solution in warm water using a soft cloth.
PAGE 2
. To determine if any trimming will be required on your wall surround, BEFORE APPLYING ADHESIVE! Set Back Panel in place, raised approximately 1/8” above tub surface and centered on back wall. A few strips of masking tape will hold the panel in place while you draw a pencil line all around the panel. NOTE: These lines will be a guide when you are ready to permanently install the panel. Temporarily tape Corner Panel in position, be sure soap dishes are against the back wall.