Installation Instructions

Sl-154 (06•06)

SHOWERWALL INSTALLATION

Trial fit the Corner Panel and both right and left Side Panels in place before applying any adhesive or mounting screws. Be sure

to check alignment of the front edges of the Side Panels with the front surface of the shower receptor threshold as shown in

drawings Fig. H or Fig. J.

If any gap is present between the backside of the mounting flange and the face of the stud, a tapered piece of wood (shingle)

should be inserted to take up the space. Install “deck” screws through shims during permanent installation.

Now that the Corner and both Side Panels are aligned horizontally level and vertically plumb in alcove, using two of the previously

drilled 5/32” dia. holes in each panel as a guide - drill reference holes (prefer one on top, one on side for Side Panels, 2 on top for

Corner Panel) into the studs with the appropriate drill bit for the “deck” screws, drill 1/8” dia. holes - max.

These holes will align unit when you are ready for the permanent install.

1. Apply a bead of “clear” silicone sealant, approximately centered on the narrow flanges of the shower receptor - both sides

and also where Side Panel contacts threshold. See drawing: Fig. H or Fig. J as determined by shower receptor model.

2. As noted in “Rough-in” drawings - Figures A and B - “Apply a bead of silicone sealant to the stud faces that make contact with

the back surfaces of the Corner and Side Panels.

3. Set Corner Panel in place, apply downward pressure to compress sealant, secure in place with “deck” screw in pre-drilled

“stud” reference hole - install and tighten remaining screws. Apply a bead of silicone sealant (clear) to one of the grooves. See

drawing Fig. F.

4. The Side Panel has (3) three latches located on the edge of the blade that lock into corresponding slots in the Corner Panel

groove. Hold Side Panel approximately 1/2” (inch) above Corner Panel. Align and insert latches into slots, lower Side Panel

to lock in place - top edges should be level. Wipe away any excess silicone sealant that may have seeped out onto the

finished surface. See drawing, Fig. F.

5. Apply silicone sealant to remaining Corner Panel groove as in Step 3 and repeat procedure as outlined in Step 4 for installing

the remaining Side Panel.

TRIAL FIT THE CORNER PANEL AND BOTH RIGHT AND LEFT SIDE PANELS IN PLACE BEFORE APPLYING

CORNER PANEL MUST BE INSTALLED FIRST!