Installation Instructions

ManualsBrandsE. L. Mustee ManualsBathE.L. Mustee Stylemate 19.5" x 24.375" x 19.5" x 70" Brushed Nickel Framed Pivot Neo-Angle Shower Enclosure with Clear Glass

Mustee Stylmate 09-12-2011

E. L. MUSTEE & SONS, INC.

Stylemate

NEO-ANGLE SHOWER ENCLOSURE

INSTALLATION INSTRUCTIONS

5431 West 164th Street Cleveland, Ohio 44142

COASTAL

INDUSTRIES INC.

P.O. Box 16901

Jacksonville FL 32245

Phone: 1-800-874-8601

Fax: 1-904-641-1697

Should you have any problems with

this Shower Door, please contact us at:

Summary of content (4 pages)

PAGE 1
E. L. MUSTEE & SONS, INC. 5431 West 164th Street Cleveland, Ohio 44142 Stylemate NEO-ANGLE SHOWER ENCLOSURE INSTALLATION INSTRUCTIONS Should you have any problems with this Shower Door, please contact us at: COASTAL INDUSTRIES INC. P.O.
PAGE 2
STYLEMATE NEO ANGLE SHOWER ENCLOSURE KEY LETTER A PART NUMBER 401 DESCRIPTION WALL JAMB B b1 b2 b3 b4 b5 ---235 404 407 6112PHS C 154 B SIDE PANEL ASSEMBLIES SIDE PANEL RAILS SIDE PANEL EXPANDER SIDE PANEL CORNER POST SIDE PANEL ASSEMBLY SCREW (not shown) SIDE PANEL GLAZING VINYL (not shown) 2 4 2 2 8 -- C c1 c2 c3 c4 c5 c6 c7 c8 c9 c10 c11 c12 c13 c14 c15 ---440 441 441 227 429 226 CP201 CP209 FW 10-093 98-42 C 176 B 6112PHS 6112PHS 5112FHSL C 173 B DOOR FRAME ASSEMBLY DOOR FRAME HEADER / SILL DO
PAGE 3
STEP 1 Positioning Wall Jambs Determine the curb centerline, then offset and mark a line 3/8 of an inch toward the outside of shower as shown in figure 1. Separate the Wall Jambs (A) from their respective End Panels (B) as shown in exploded view. Place Wall Jambs (A) up against shower walls . . . aligning their outside legs with the offset mark previously marked on base ledge. Use a level to plumb Wall Jambs (A).
PAGE 4
STEP 6 Caulk for a leak proof installation STEP 4 Door Frame Installation Fig. 5a Place the Door Assembly (C) between the Panel Assemblies (B) as shown. Starting with the pivot side first . . . engage the full length of the Panel Assembly tongue with the Door Assembly groove channel as shown in figure 5a. Snap the Door and Panel assemblies together. Make sure that Door and Panel assemblies are secured their entire length. Repeat step for the other side.