Installation Instructions

Sl-165 (07•07)

Corner Panel -

Permanent Installation

Adhesive Pattern: Apply a 1/4” dia. bead

of adhesive to the back side of one of the

Corner Panels. Refer to FIG. 4 for rec-

ommended adhesive pattern. Follow

“ADHESIVE NOTE / VENTING METHOD”.

NOTE: You may also use large head di-

ameter tacks or “Roofing” style nails next

to “overlap” edge of panel if required.

These nails do not have to be removed

as they will be covered by Center Panel.

(See detail in FIG. 4 for suggested nail

placement.)

Note: Any dirt or molding/body oils on

panel overlap area may affect adhesion.

To avoid adhesion problems, wash over-

lap area of Corner Panels with rubbing

alcohol after installation and prior to in-

stalling Center Panel.

INSTALLATION:

FIG. 3

FIG. 4

ADHESIVE NOTE:

We recommend that each panel be “vented”.

VENTING METHOD -

Apply adhesive to back

side of panel as illustrated, align all guide lines and

press panel firmly to wall, compressing adhesive,

hold in approximately 30 seconds, then pull panel

away. Remove protective liner from tape strip (if

required), wait 4 minutes. Carefully reposition panel

and press back firmly into place. To insure proper

adhesion, go over entire tub surround 20 minutes

after all (3) three panels are in place, pressing firmly

by hand or tapping with a padded block. Wait 24

to 36 hours (cure time) before using tub or shower.

CORNER PANEL

INSTALLATION HINT:

If existing wall condition does not allow

panel edges to lay flat, unit may be ‘blocked’

as shown below while adhesive cures.