Installation Instructions

MUSTEE
SHOWER WALL
INSTALLATION INSTRUCTIONS
MODEL 260
•FITS SHOWER BASES
*
48" to 60" WIDE
30" to 40" DEEP
MODEL 247
•FITS SHOWER BASES
30" to 48" WIDE
30" to 36" DEEP
MODEL 237
•FITS NEO-ANGLE OR CORNER
MODEL SHOWER BASES
UP TO 42" x 42"
*
WILL ALSO FIT 42" x 36" &
42" x 42" SHOWER BASES BY
REVERSING CORNER PANELS
Quality Plumbing Products
E.L. MUSTEE & SONS, INC.
5431 West 164th Street • Brook Park, Ohio 44142
Follow the same basic procedure for positioning the Side
Panels as you did for the Center Panel. Align edge of Side
Panel with front of shower base, remember to align top
edges. Draw pencil guide lines. The Side Panel for the
fitting end of the shower will have to be carefully
measured, marked and drilled to accept the valve stem(s)
and possibly shower head pipe. Before doing any drilling,
recheck your dimensions.
Apply adhesive to Center Panel using approximately 1/8"
diameter bead. Align panel with pencil guide lines. Short
strips of masking tape may be applied to hold panel in
place until adhesive begins to bond. Repeat this
procedure for the side panels. IMPORTANT: Be sure to
follow adhesive manufacturer's directions for "venting" if
applicable! Excess adhesive should be removed with
mineral spirits immediately. (NOTE: After cleaning
excess adhesive, wash area completely with a soap/water
solution to neutralize solvent.)
Apply adhesive to back side of formed corner as shown in
illustration (Fig. 4). Align top edge of corner panel with
guide lines, press in place working from top to bottom.
Short strips of masking tape may be applied to hold corner
panels in place until adhesive begins to bond. Repeat for
remaining corner panel.
Caulk all edges of your shower wall surround with a quality
waterproof sealant, remember to caulk around shower
head pipe and valve stem holes. Allow adhesive and
caulking to fully cure before using shower.
Re-install valve stem handle(s) and shower head.
2.
3.
4.
5.
6.
Fig. 4
SI-196 (9•06)
Warning: Do not use spray-on cleaners that require daily use without immediately rinsing to stop
chemical reaction. Damage will result and void warranty.
The surface of your Shower Wall Surround may be cleaned with a mild soap solution in warm water
using a soft cloth. For stubborn stains use "Soft-Scrub" by Clorox or Lysol "Tub &Tile Cleaner" or a
powdered detergent such as "Spic-n-Span". Never use an abrasive scouring powder or steel wool
pads as they will dull the surface. A periodic coating of a silicone based marine polish will help retain
the fine finish.
CARE & CLEANING
PART NUMBER
WHITE BONE
37.301 37.304
47.301 47.303
47.302 47.304
48.320 48.325
48.321 48.326
7
3/4
"X7
3/4
" CORNER PANEL WITH 3 SHELVES (MDLS. 237&247)
30"X71
1/2
" FLAT PANEL (MDLS. 247&260)
36"X71
1/2
" FLAT PANEL (ALL MODELS)
5
1/2
"X14" R/H CORNER PANEL WITH 2 SHELVES (MDL. 260)
5
1/2"
X14" L/H CORNER PANEL WITH 2 SHELVES (MDL.260)
DESCRIPTION
SI-196 (9•06)