Installation Instructions

COUNTERTOP CUTOUT DETAILS
Sl-163 (04•06)
SINK OUTLINE
DO NOT CUT
ON THIS LINE!!
The rear ledge of your Hospitality Sink will accept many different faucets; 4” Center Set either right or left, 8”
Center Set on center. Depending on the model faucet you choose, the appropriate holes will have to be drilled.
You will notice that there are five indented hole locators molded-in, on the underside of the rear ledge, do not cut
out faucet holes until you have measured the actual faucet (some single lever faucets require a large center /
Supply hole and small diameter mounting holes). A 1” diameter, fine tooth hole saw with center drill pilot would
normally be used for the majority of faucet hole drilling. Drill from underside of rear ledge to mark center, turn
upright to finish cutting with hole saw.
INDENTED HOLES ON UNDERSIDE OF
REAR LEDGE TO BE DRILLED OUT BY
CUSTOMER TO ACCEPT EITHER 4" OR
8" SUPPLY CENTER FAUCETS
FAUCET HOLE DETAIL
3.
Install "Basket" Style Drain Assembly “Not furnished” per manufacturer’s instructions. The Hospitality Sink is
furnished with a 3 1/2- diameter drain hole.
Install Mounting Studs (2) in each corner lug-CAUTION- DO NOT OVER TIGHTEN!! A standard 5/16” socket or wrench
is required. Screw stud in place until nut makes contact with bottom of lug — continue 1/4 turn, maximum. Repeat this
operation for each mounting lug. — See “TYPICAL STUD INST
ALLATION"
HINT:
Apply a dab of siliconized
sealant to threads to
lubricate stud and ease
installation.
4.
5.
Apply a bead of clear siliconized sealant (not furnished) all around the underside of the rim in the molded-in-groove
_
See Detail Dr
awing. Place Hospitality Sink into the countertop cutout, secure from the underside with hardware
provided.You will need a 7/16” socket or wrench to secure Mounting Nuts (4) in place. Wipe away any excess
sealant that squeezes out during tightening.
*Slilconized Sealant such as:
CELULON™ Plumbing & HVAC
Adhesive Sealant by Red Devil
®
APPLY A BEAD OF SILICONIZED SEALANT*
APPROXIMATELY 3/8" DIAMETER THIS AREA,
ALL AROUND UNDERSIDE OF RIM.
Complete water supply and proper sanitary waste trap connections as specified by local code requirements.
Number in ( ) parenthesis refer to Key Numbers in Parts List.
TYPICAL STUD INSTALLATION
Sl-163 (04•06)
2
3
6.
7.
*
HELPFUL HINT
*
After making cuts along sides of cutout, secure a
board as shown to prevent cutout from prematurely
dropping and possibly damaging surface of countertop.
Make these cuts first!
Masking Tape
(Optional)
Detail Dr
awing