Installation Instructions

MODEL 15W

(15WK)

WALL MOUNTED

LAUNDRY TRAY

1. Secure Wall Plate to wall using both 5/16” x 2” Lag Screws. Locate mounting holes 1-1/2” below desired

tray height as measured from top edge of rim.

Hole Siz

Wood Walls (open stud) – Drill 3/16” diameter holes into wall studs or plate.

Cement/Masonry Walls – Drill 3/8” diameter holes for 5/16” plastic anchors.

Check level, tighten securely.

2. Turn Laundry Tray upside down on a smooth, clean surface to allow for the removal of the 1” (inch) dia.

faucet hole plugs which are located on 4” (inch) centers. Be sure to allow for rear ledge overhang – approx.

5/8”. This will give more support to the ledge area. The hole plugs may be removed by punching out, using

a 3/4” (inch) pipe nipple with one end chamfered to ease cutting or by drilling with a 1” (inch) diameter

hole saw.

3. Assemble Molded Side Fillers – insert tab between lugs under rear ledge. Position bottom plate over

molded lug. Insert 1/4” x 3/4” Drive Rivet into lug hole, two rivets per side filler. Hammer to lock in place.

4. Mount faucet (not furnished) on tray. Faucet holes are on 4” (inch) centers. If “clamp-on” stye faucet is

preferred – optional faucet block Part No. 20.600 is available.

5. Mark location of molded side filler mounting tab holes. Remove Laundry Tray and follow anchoring

procedures as outlined in Step 1. Reinstall Laundry Tray. Be sure to use the 5/16” dia. Flat Washers

under the heads of the 5/16” Lag Screws. The washers will keep the Lag Screws from digging into

and possibly damaging the side filler tab.

6. Make final plumbing connections in compliance with local code regulations.

MUSTEE

E.L. MUSTEE & SONS, INC.

5431 West 164th Street • Brook Park, Ohio 44142

SI-140 (05•06)

PAGE 1
MUSTEE 15W (15WK) MODEL WALL MOUNTED LAUNDRY TRAY 1. Secure Wall Plate to wall using both 5/16” x 2” Lag Screws. Locate mounting holes 1-1/2” below desired tray height as measured from top edge of rim. Hole Size: Wood Walls (open stud) – Drill 3/16” diameter holes into wall studs or plate. Cement/Masonry Walls – Drill 3/8” diameter holes for 5/16” plastic anchors. Check level, tighten securely. 2. Turn Laundry Tray upside down on a smooth, clean surface to allow for the removal of the 1” (inch) dia.
PAGE 2
MODEL 15W (15WK) IAPMO® LISTED FILE NO. 0635 PARTS ILLUSTRATION Cleaning Note: Most stains that you may acquire in your Model 15W Laundry Tray may be removed with common household cleanser or liquid cleaner. Stubborn stains may be removed with a bleach solution – follow bleach manufacturer’s recommended procedures pertaining to safety, handling and use of their product. PARTS LIST KEY NO. PART NO. 1 2 3 4 5 6 7 8 9 10 11 15.101 19.203 19.202 18.