Installation guide

18
Check if the USB cable is well connected to the controller and the charge
port and if the board is powered on. If the connection is good and the controller
is charging, the controller's red light will turn on. When fully charged the red
light will turn off. In any other situation please contact the E-GO customer
service.
5.1
MY CONTROLLER
DOESN'T CHARGE
If during your ride you hear a beep, the board stops and only the controller's
blue light is flashing, it means the control signal is lost. Turn the controller
off and then on again to reconnect.
Control signal loss will occur when the distance between your board and
controller becomes too great. To reconnect close the distance between
the two.
3.7
3.8
Check if the charge cable is connected to the board and if the charger is
connected to a standard A/C power source. If the connection is good and
the board is charging, the charger's battery status indicator will turn red.
When fully charged it should turn green. In any other situation please contact
the E-GO customer service.
4.1
MY BOARD DOESN'T
CHARGE
YUNEEC.COM