UMX F-27 Evolution BNF Basic Manual

Program Your Transmitter
1. Start with a clean model memory slot.
2. Set the model type to “Airplane”.
3. Assign channel 5 (Gear) to a 3-position switch.
Switch B is used in the table shown.
4. Set the Dual Rate/Expo settings to the values given in
the table for AS3X Mode only.
5. Set the timer to 5 minutes.
6. Leave all other settings at the default values.
Switch B will now control the fl ight mode function.
Switch position 0 = SAFE
®
Mode
Switch position 1 = SAFE
®
Mode
Switch position 2 = AS3X Mode
If, after fl ying the aircraft, more or less exponential or dual
rate values are desired, those may be adjusted up or down
to suit your fl ying style.
Dual Rate/Expo
(AS3X Mode only)
Switch B
DR Expo
Aileron 70% 30%
Elevator 70% 30%
Timer
Mode Count Down
Time 5:00
Start Throttle Out
Over 25%
One Time Inhibit
FUNCTION LISTSETUP LIST
F-Mode Setup
Switch 1 Inhibit
Switch 2 Inhibit
Model Type
Airplane
Channel Assign
Channel Input Confi g
1 Throttle
2 Aileron
3 Elevator
4 Rudder
5 Gear Switch B
6 Aux 1
Frame Rate
22ms
DSMX
DX6e, DX6, DX8e, DX8 (Gen 2), DX9, DX18, DX20, iX12
4
EN
First Flight Preparation
• Remove and inspect contents
• Begin charging the fl ight battery
• Program your computer transmitter
• Install the fl ight battery in the aircraft (once it has been
fully charged)
• Bind your transmitter
• Perform a control direction test
• Familiarize yourself with the controls
• Find a suitable area for fl ying
Flying Checklist
❏ Always turn the transmitter on fi rst
❏ Plug the fl ight battery into the lead from the ESC
❏ Allow the ESC to initialize and arm properly
❏ Fly the model
❏ Land the model
❏ Unplug the fl ight battery from the ESC
❏ Always turn the transmitter off last
Transmitter Setup