UMX Cessna 182 Manual

3
EN
To register your product online, go to www.e-fliterc.com
Installed
Motor: 180BL 2500Kv Brushless
Outrunner (EFLUM5615)
Receiver : DSMX
®
6 Ch Ultra Micro
AS3X
®
/SAFE Receiver (EFLU5864)
Ultra Micro Rotary Servo (EFLU5610)
Required to Complete
Recommended Battery: 280mAh 2S
7.4V 30C Li-Po, 26AWG (EFLB2802S30)
Recommended Battery Charger:
Celectra
™
2S 7.4V DC Li-Po Charger
(EFLUC1007)
Recommended Transmitter:
Spektrum
™
DSM2
®
/DSMX
®
full range
(DXe and up)
20.3 in (516mm)
25 in (635mm)
4.6 oz
(130 g)
SAFE
®
Select Technology .......................................4
Transmitter and Receiver Binding ...........................4
Low Voltage Cutoff (LVC) ........................................5
Transmitter Setup ..................................................5
ESC/Receiver Arming, Battery Installation and
Center of Gravity ....................................................6
Control Direction Tests ...........................................7
Control Centering ..................................................8
Factory Control Horn Settings.................................8
Flying Tips and Repairs ..........................................9
Post Flight Checklist ..............................................9
Power Components Service .................................10
Troubleshooting Guide .........................................11
Troubleshooting Guide (Continued) .......................12
Limited Warranty .................................................12
Warranty and Service Information ........................14
IC Information ......................................................14
FCC Information ...................................................14
Replacement Parts ...............................................55
Optional Parts and Accessories ............................56
Table of Contents
Specifications

1. Charge flight battery.
2. Install flight battery in aircraft (once it
has been fully charged).
3. Bind aircraft to transmitter.
4. Make sure linkages move freely.
5. Perform Control Direction Test with
transmitter.
6. Perform AS3X control Direction Test with
aircraft.

7. Set dual rates.
8. Adjust center of gravity.
9. Perform a radio system Range Check.
10. Find a safe and open area.
11. Plan flight for flying field conditions.
12. Set fight timer for 6 minutes for first
flight
Preflight Checklist
Wing Area: 93 sq. in.
(601 sq. cm.)