EFL8350 E-flite T-28 Trojan 1.2m Manual

EN
Control Horn and Servo Arm Settings
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the AR636
gain values may need to be adjusted. Refer to the Spektrum AR636 manual for
adjustment of gain values.
After fl ying, you may choose to adjust the linkage positions for the desired
control response. See the table to the right.
Horns Arms
Elevator
Ailerons
Flaps
Rudder
Nose Wheel
More control throw Less control throw
Propeller Installation
IMPORTANT: It is recommended to install the propeller after all system setups
are completed to reduce the chance of accidental propeller strike.
1. Use a tool to remove the spinner (A) from the collet (B).
2. Install the propeller with the size numbers (12 x 7) facing out from
the motor.
3. Use a tool to re-install the spinner and secure the propeller in place.
Model Assembly Continued
B
A
7