EFL5550 E-flite Radian XL 2.6m Manual

EN
Model Assembly Continued
Wing Installation
1. Place the assembled wing (A) over the fuse and connect spoiler servo
connection (B) to the servo extension labeled SPOILER (C).
2. Carefully set the wing on top of the fuse, being careful not to pinch any
wires.
3. Secure in place using the included (2) 3 x 16mm (D) and (3) 3 x 20mm (E)
screws.
A
D
E
Control Horn and Servo Arm Settings
The table to the right shows the factory settings for the control horns and servo
arms. Fly the aircraft at factory settings before making changes.
NOTICE: If control throws are changed from the factory settings, the AR636
gain values may need to be adjusted. Refer to the Spektrum AR636 manual for
adjustment of gain values.
After flying, you may choose to adjust the linkage positions for the desired
control response. See the table to the right.
Horns Arms
Elevator
Elevator
Flaps
Tail wheel
Rudder
Elevator
Flaps
Tail wheel
Elevator
Flaps
Tail wheel
More control throw Less control throw
Control Surface Centering
After assembly and transmitter setup, confirm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the
control surfaces by adjusting the linkages.
If adjustment is required, turn the clevis on the linkage to change the length of
the linkage between the servo arm and the control horn.
After binding a transmitter to the aircraft receiver, set the trims and
sub-trims to 0, then adjust the clevises to center the control surfaces.
C
B
7